Miovisin

To obtain rapid and complete miosis after delivery of the lens in cataract surgery as well as in penetrating keratoplasty, iridectomy and other anterior segment surgery where rapid complete miosis is required.

Miovisin-E is for intraocular irrigation only. A freshly prepared 1% solution should be used in the anterior chamber of the eye during surgery.

Adults and Elderly: In most cases a satisfactory miosis, which will last for approximately 20 minutes, is produced in seconds by 0.5 - 2.0ml. A second application may be made at the discretion of the surgeon if prolonged miosis is required.

Children:

Safety and effectiveness in children has not been established.

Route of administration: Intraocular irrigation during surgery.

There are no known contra-indications to the use of Miovisin-E in cataract or anterior segment surgery.

If miosis is to be obtained quickly and completely, obstructions to miosis such as anterior or posterior synechiae may require surgery prior to administration of Miovisin-E. In cataract surgery Miovisin-E should be used only after delivery of the lens.

If blister or paper backing is damaged or broken, sterility of the Miovisin-E vial cannot be assured. The solvent should be in the upper chamber before use. If the centre rubber plug in the univial does not go down when the plunger-stopper is pressed or is already down, the vial should not be used.

Aqueous solutions of Miovisin-E are unstable. The solution should therefore be prepared immediately before use. Any remainder should be discarded.

Not applicable.

Adverse reactions which are indicative of systemic absorption have been reported rarely in the literature. Symptoms include bradycardia, hypotension, flushing, breathing difficulties and sweating. Isolated cases of corneal oedema, corneal clouding and corneal decompensation have been reported with the use of Miovisin-E, although a causal relationship has not been established.

The symptoms of overdosage are likely to be effects resulting from systemic absorption, ie bradycardia, hypotension, flushing, breathing difficulties and sweating. Atropine sulphate (0.5 - 1mg) should be given intramuscularly or intravenously and should be readily available to counteract possible overdosage. Adrenaline (0.1 - 1mg subcutaneously) is also of value in overcoming severe cardiovascular or bronchoconstrictor responses.

Acetylcholine is a physiological neuromediator of postganglionic parasympathetic nerve fibres (muscarinic action), skeletal muscles and ganglia of the sympathetic system (nicotinic action).

The ocular parasympathetic receptors of the muscarinic type are very numerous and localised:

- at the level of the pupillary sphincter, whose contraction causes miosis

- at the level of the ciliary muscle, whose contraction allows accommodation and facilitates the flow of the aqueous humor by opening of the trabecular meshwork. In addition, the acetylcholine can have an inhibitory effect on the aqueous secretion. These two last factors result in a decrease in the intraocular pressure.

- at the level of the lacrimal glands, whose stimulation causes tearing.

Topical: Not applicable.

The active ingredient of Miovisin-E is acetylcholine, a natural neurohormonal transmitter the pharmacological activity and toxicity of which have been clearly defined. The effect of Miovisin has been demonstrated in several animal studies. The addition of electrolytes in Miovisin-E resulted in very good local tolerability in the cat. Given that a low single dose of acetylcholine is administered by the intraocular route, the risk of systemic toxicity is very low.

None known. The filter hub is recommended only for use with Miovisin-E.

The reconstituted preparation is a clear, colourless solution.

Warning: Do not use if blister or peelable backing is damaged or broken. Open under aseptic conditions only. The contents of the blister can be guaranteed as sterile.

Directions for preparing Miovisin-E

1. Inspect unopened blister to ensure that it is intact. Peel open blister.

2. Aseptically transfer the ampoule, vial and syringe tip filter hub to sterile field. Maintain asepsis during preparation of solution.

3. Aseptically attach a sterile 18 to 20 gauge, bevelled needle to the luer tip of a sterile disposable syringe with twisting motion to assure secure fit.

4. Break open the ampoule containing the solvent. The One Point Cut (OPC) ampoule must be opened as follows: Hold the bottom part of the ampoule with the thumb pointing to the coloured point. Grasp the top of the ampoule with the other hand, positioning the thumb at the coloured point and press back to break at the existing cut under the point.

5. Remove the needle protector and withdraw the solvent from the ampoule into the syringe. Discard ampoule.

6. Remove and discard plastic cap from top of vial.

7. Insert the needle through the centre of the vial stopper.

8. Transfer the solvent from the syringe to the vial.

9. Shake gently to dissolve drug.

10. Slowly withdraw the solution from the vial through the needle into the syringe.

11. Discard needle.

12. Aseptically open tip filter hub pouch.

13. Aseptically attach filter hub onto luer tip of syringe with a twisting motion to assure secure fit.

14. Aseptically attach a sterile blunt tip irrigation cannula to male luer of filter prior to intraocular irrigation.

15. Discard appropriately after use. Do not reuse the filter hub.

The solution must be mixed just before use since aqueous solutions of acetylcholine are unstable. Only clear and colourless solutions should be used.

Miovisin-E should not be re-sterilised. The filter hub is recommended only for use with Miovisin-E. Aspiration through the filter is not recommended. However, if utilised, discard needle and syringe filter to prevent recontamination of fluids during injection.

Do not aspirate and inject through the same filter.

Do not use unless a clear and colourless solution is produced. For single use only. Discard any unused solution.